These files can be printed unlimited times with a 3D printer, check the webshop here for additional images and products.
Sd.Kfz. 250 Tow Coupling
Tow coupling for Sdkfz 250 or Sdkfz10 halftracks. Assembled, or separate part assembly, that can be fully articulated.
WW2 German OVM Tools Part 1
Part one of 1/35 scale OVM tools used on ww2 German vehicles. These are tools and mounts designed for Sdkfz 250, however, tools were standardized, and would fit any ww2 vehicle. Tools are provided with, and without mounts for use on different vehicles.
Included in set:
- 250 starter crank handle
- 250 tow cable bracket and retaining straps (for fender mount)
- Grose Drahtschere plus 250 mount
- kurze brechtstange , 3 versions, with mounts
- Klauenbiel with mounts (2 types)
- Lange Axt
- Lange kreuzhaxe plus 250 fender mounts
- Langer Spaten
WW2 German 4ton Jack
1/35 ww2 German 4 ton jack. Designed for Sdkfz 250, but will fir other vehicles too. Was used on Sdkfz 10, 11, 251, 234. One was also present in Kfz70 vehicles, like MB 1500A/S.
Includes jack on sdkfz 250 mount (fits 234 too).
Standalone jack, with separate screw part. Cutting down screw to needed length, you can use jack either stowed, either in use.
Crank handle, and crank handle extensions are included too.
Wooden block for sdkfz 250 is also included.
Small Chain
Small chain for use of securing tools, pins etc on scale models.
Scale for best appearance/scale needed.
WW2 German Brake Light and Reflector
1/35 brake light and reflector. Designed for Sdkfz 250, but will fit almost every vehicle produced prior switch to single convoy light.
Sd.Kfz. 250/9 Ausf.A Detail Parts
These parts are designed to add details to Dragon Sd.Kfz.250/9 ausf A. Should fit any other 1/35 Sd.Kfz.250 ausf A version aswell.
Includes 2 type fender boxes, used on 250/9, width indicators, turn indicators (2 type). Brackets for mounting large right fender box. 250/9 had those brackets, but no box mounted.
For turret, wire screen brackets(you will need to mirror the parts, models for one side only), plus turret antenna mount.
Jerry can mount. Used on both 250A and B.
Use 0.3mm wire for width indicators. Although indicators can be printed as single part, using wire makes them very durable, and easy to straighten in case of mishandling during assembly.
Panzer 2m Antenna
1/35 scale 2m antenna for German panzers
3 versions, one with 0.4mm diameter stub, other, with 0.3mm hole for wire. Plus one with antennafuss 2.
Notek Tarnscheinwerfer and Convoy Light
Models were designed to fit 1/35 Sd.Kfz 250 ausf.A, and includes fender mounts for this kit. However, both lights can be used on pretty much any other vehicle.
Includes both, cast and stamped versions (both front and back). Tarnscheinwerfer mount with contact cover, for use with light removed.