1⁄350Water-line Conversion of Injection Molded Full Hulls
Here basically is the finished result. You may notice that the base plate strake is made of two pieces, that's because I had run out of the material to do it with in one piece. I joined the two pieces by drilling a hole in mated ends and gluing in a metal rod. It worked nicely and is as rigid as a one piece length. One thing I forgot to show for the process was the test fitting of the decks. This I did throughout all stages to make sure everything fit properly up to the end result.
Copyright ©2020 by Kym Knight. Images and/or videos also by copyright holder unless otherwise noted. The views and opinions expressed herein are solely the views and opinions of the authors and/or contributors to this Web site and do not necessarily represent the views and/or opinions of Armorama, KitMaker Network, or Silver Star Enterrpises. All rights reserved. Originally published on: 2010-02-03 00:00:00. Unique Reads: 11629