login   |    register

Scale Modeling Sponsors

See Your Ad Here!

Scratchbuilders!
Built a model or part from your own materials lately?
Hosted by Mike Kirchoff
Material for very thin leather straps?
Phil5000
Visit this Community
New Zealand
Joined: May 13, 2013
KitMaker: 102 posts
Armorama: 94 posts
Posted: Wednesday, March 01, 2017 - 03:08 PM GMT+7
Hi guys. I'm working on some US tankers WW2 1/35 and I want to make the leather straps for their helmets. I would just cut up some paper strips but the paper just frays or tears if you cut it that small. What else could I use? Do they do plastic sheet that thin?

Cheers.
Vicious
Visit this Community
Queensland, Australia
Joined: September 04, 2015
KitMaker: 747 posts
Armorama: 565 posts
Posted: Wednesday, March 01, 2017 - 04:26 PM GMT+7
I use the foil that seals the tins of Milo....yes the chocolate powder... ....it is thick enough to resist shear and easy to work, but in the other hand is very fine, or masking tape Tamiya.
GazzaS
#424
Visit this Community
Queensland, Australia
Joined: April 23, 2015
KitMaker: 2,911 posts
Armorama: 1,093 posts
Posted: Wednesday, March 01, 2017 - 08:56 PM GMT+7
Phil,
Try aluminium foil. The stuff that comes on Champagne type bottles is a bit firmer than the kitchen kind. Just make sure your knife is very sharp.

Gaz
RobinNilsson
Visit this Community
Stockholm, Sweden
Joined: November 29, 2006
KitMaker: 1,918 posts
Armorama: 1,704 posts
Posted: Wednesday, March 01, 2017 - 09:44 PM GMT+7
I have the habit of taking things apart to check if there is something useful for modelling inside.
Cables contain copper wires of various thicknesses.
When I disassembled the cable on some broken mobile phone earplugs I found that the shielding consisted of a narrow strip of thin copper foil wound around the wires inside. They were less than 1 mm wide and my thought then was that they would be ideal for safety harness belts.

Another possibility is to use thin copper wire (or aluminum if you can get hold of thin alu-wire). Fasten (tape down the ends) short pieces on a hard (steel plate) surface and flatten them by rolling a steel pipe (or other hard cylinder) along them (press hard).
Copper can be softened, if needed, by heating with a flame.
The rolling will flatten the wire and also make it slightly longer so you may need to adjust the adhesive tapes holding them down. The flattened wire will have rounded edges and be smooth so they willresemble leather straps.
/ Robin
Neo
Visit this Community
North Carolina, United States
Joined: January 20, 2005
KitMaker: 706 posts
Armorama: 584 posts
Posted: Tuesday, April 04, 2017 - 02:30 PM GMT+7
Phil,

Painters tape or masking tape. Hit end w/ super glue and it will never drop off.
ronbo070
Visit this Community
Alabama, United States
Joined: February 01, 2015
KitMaker: 19 posts
Armorama: 15 posts
Posted: Wednesday, June 21, 2017 - 07:49 PM GMT+7
If you are talking about the strap on either side they are spring steel wrapped in leather. You could duplicate them with thin strips of metal wrapped in paper tape and paint them accordingly.

The straps were designed to put pressure on the ear flaps and speakers. They were attached to the helmet by a single rivet and could swing out of the way. I hope this helps..